aci 224r 01 pdf

224R-01 Control of Cracking in Concrete Structures

224R-2 ACI COMMITTEE REPORT Chapter 5—Long-term effects on cracking, p. 224R-24 5.1—Introduction 5.2—Effects of long-term loading 5.3—Environmental effects

ERRATA Control of Cracking in Concrete Structures (ACI 224R-90

The combined document and supplement supersede ACI 224R-89. Section 4.2, page 16, first sentence, revise: Superscript reference from 4.1 to 1.1.

Control of Cracking in Concrete Structures

ACI 224R-01 supersedes ACI 224R-90 and became effective May 16, ... 3.4.1 Relative humidity and drying time—Relative humidity ... in Table 3.1; the concrete had ...

224R-01 Control of Cracking of Concrete Structures

ACI 224R-01 Reported by ACI Committee 224 Control of Cracking of Concrete Structures

Cracks in concrete: Part 2

In the re p o r t ACI 224R-80, “Co n t r ol of Cracking in St ru c t u re s,” the following general guide is given as a de-

C o n c r ete Perspectives Concrete Construction: Resources for

4.4 of ACI 224R-90 indicates that a p o r tion of the cracks in a stru c t u r e ... ues in Table 4.1 by a significant amount, even when other re p o r t re c -

CHAPTER 62-761 UNDERGROUND STORAGE TANK SYSTEMS

Meets the design and construction standards of ACI 350R -89 and ACI 224R-89; or 2. Is applied to the concrete in accordance with NACE International Standard RP0892 -92.

Ref. 620.136 ACIp 1990 Pt.3

Preparation of Notation for Concrete (ACI 104-71) (Revised 1982) (Reapproved 1987) 104 ... Control of cracking in Concrete Structures-ACI 224R-89 224

Control de la fisuracion

ACI 224R-01 Control de la Fisuración en Estructuras de Hormigón Informado por el Comité ACI 224 Florian Barth Presidente Robert J. Frosch* Secretario

15A NCAC 02N .0907 NATIONAL CODES OF PRACTICE AND INDUSTRY STANDARDS

ACI International 224R-89, "Control of Cracking in Concrete Structures" is hereby incorporated by reference including subsequent amendments and editions.

Control de la fisuracion INTI

ACI 224R-01 Control de la Fisuración en Estructuras de Hormigón Informado por el Comité ACI 224 Florian Barth Presidente Robert J. Frosch* Secretario

Guidance Periodic and Formal AST Inspections 04-26-12

Concrete Institute reports ACI 350R-89 and ACI 224R-89; or Concrete structures must be designed, constructed, and coated with an approved suitable material

Guidance Periodic and Formal AST Inspections Final

Concrete Institute reports ACI 350R-89 and ACI 224R-89; or Concrete structures must be designed, constructed, and coated with an approved suitable material

ACI 224.3R-95 Joints in Concrete Construction

ACI 224R-92 One to three times the height of the wall in solid walls. Table 1.2—Expansion joint spacings. Author Spacing Lewerenz (1907) 75 ft (23 m) for walls.

Appendix A References Publications, US Army Corps of Engineers

ACI Committee 116 “Cement and ... “Control of Cracking in Concrete Structures,” ACI 224R-80 Revised 1984, ACI Journal, December 1972, pp 717-753. ACI Committee 439

APPENDIX A LITERATURE REVIEW Table of Contents

The ACI 224 report ... The American Concrete Institute 1963 Building Code ... • The report uses the crack width values developed in ACI 224R-01 as guidelines ...

Causes and Cures of Cracking FPA Nov 08 Welcome to the

1 ACI 224R-90, Table 4.1. ROUTING AND SEALING. 11/12/2008 74 Routing and Filling • Scabbler (crack chaser) routs crack 1 in. (25 mm) wide and 1-2 in. deep

CONTROL JOINT FORMERWaterstop & Accessories

Refer to ACI 224R-90 Chapter 3 for more information on drying shrinkage cracks and ACI 302.1R-89 Chapter 2.3.2 and 7.2.9 for joint location and design. INSTALLATION

Cracks in Structural Concrete Concrete Texturing Tools and

ACI 224R-01, “Control of Cracking in Concrete Structures,” indicates 0.016 in. as a reasonable crack width for reinforced concrete under service loads

MOX Reference Documents List. NRC: Home Page

American Concrete Institute (ACI) Codes ACI-224R-90, Control of Concrete Cracking in Concrete Structures ACI-301-99, Standard Specifications for Structural Concrete